Disposal; Packaging; Disconnection; Customer Service - Franke CRYSTAL FH CR 301 1TC Manuel D'utilisation

EN
Type of failure
A
The burner fails to ignite or
the flame is not even
B
The burner does not stay lit
C
The containers are not stable
If after the above checks the fault still occurs, get in touch with the nearest After Sales Service.

DISPOSAL

Packaging

All packaging materials (cardboard, plastic film (PE)
and polystyrene (EPS)) are marked and should, if
possible, be collected for recycling and disposed of in an
environmentally friendly way.

Disconnection

Disconnect the appliance from the mains. With a
X X
fixed appliance, this must be carried out by a qualified
electrician.
Disposal
The symbol on the product or on the
packaging indicates that the device must not
be disposed of in the domestic waste.
By disposing of the device in a proper way you help to
avoid harmful consequences to environment and health.
Further information about recycling the device is available
from the competent authority, the local refuse disposal
service or the vendor of the device.

CUSTOMER SERVICE

Refer to the contact address for your country on the
X X
back page or on our website:
– www.franke.com
FH CR 301 1TC / FH CR 302 2G / FH CR 604 4G /
FHCR 755 4G TC / FHCR 905 4G TC / FHCR 1204 3G TC
TROUBLESHOOTING GUIDE
Check if:
1
The gas or electrical supplies are not shut off
2
The gas supply tap is open
3
The gas cylinder (liquid gas) is not empty
4
The burner openings are not clogged
5
The plug end is not dirty
6
All the burner parts have been positioned correctly
7
There are no draughts near the hob
8
When lighting the burner, the knob has been pressed for enough time to
activate the protection device
9
The burner openings are not clogged near the thermocouple
10
The end of the safety device is not dirty
11
The minimum gas setting is correct
12
The bottom of the container is perfectly flat
13
The container is centered on the burner
14
The grids have not been exchanged or positioned incorrectly
– 10 –
Dispose of the device, which is to be discarded, via a
Z X
specialised waste collection point for electronic and
electrical devices.
In accordance with the article of Legislative Decree
no. 15 dated 25 July, Implementation of Directives
2002/95/EC,2002/96/EC and 2003/108/EC, regarding
the reduction of the hazardous substances used in in
electrical and electronic appliances, and waste disposal".
The barred dustbin symbol on the appliance indicates
that at the end of its working life the product must not be
disposed of as household waste.
Consequently, when the appliance has reached the end
of its working life the user must take it to a suitable
recycling centre for electronic and electrotechnical
waste, or return it to the dealer when purchasing a new
appliance of equivalent type.
Proper separate waste collection of the scrapped
appliance for subsequent recycling, treatment and
environmentally-friendly disposal helps prevent a
potentially negative impact on the environment and
health and facilitates recycling of the materials used in
appliance construction.