About This Manual; Safety Information - Franke MYTHOS FMY 839 HI Manuel D'utilisation

EN

ABOUT THIS MANUAL

This user manual applies to several models of the device.
Thus it may be possible that some of the described features
and functions are not available on your specific model.
Carefully read the user manual before using the
X X
device.
Keep the user manual.
X X
Use the device described in this user manual only
X X
according to the intended use.

SAFETY INFORMATION

For your safety and correct operation of
the appliance, read this manual carefully
before installation and use. Always keep
these instructions with the appliance even if
you move or sell it. Users must fully know the
operation and safety features of the
appliance.
Induction systems of these hobs meet
the requirements of EMC standards as
well as the EMF Directive and should not
interfere with other electronic devices.
Heart pacemakers users or other electronic
implants users should clarify with their
medical doctor or with the manufacturer
of the implants whether these devices are
sufficiently interference resistant.
The wire connection has to be done
by specialized technician. Before proceeding
with electrical connection please refer to
chapter ELECTRICAL CONNECTION.
For appliances with supply cords, the
arrangement of the terminals, or the length of
the conductors between the cord anchorage
and the terminals, shall be such that the
current carrying conductors become taut
before the earthing conductor if the cord
slips out of the cord anchorage.
The manufacturer will not be held liable for
Z X
any damages resulting from incorrect or
improper installation.
FMY 839 HI
Symbol Meaning
Warning symbol. Warning against risks of
injury.
Actions in safety and warning notes to avoid
Z X
injury or damage.
Action step. Specifies an action to be done.
X X
Result. Result of one or more action steps.
„ „
Precondition that has to be fulfilled before
9
performing the following action.
Check that the mains voltage corresponds
Z X
to that indicated on the rating plate fixed to
the inside of the product.
Means for disconnection must be
Z X
incorporated in the fixed wiring in
accordance with the wiring rules.
For Class I appliances, check that the
Z X
domestic power supply guarantees
adequate earthing.
Connect the extractor to the exhaust flue
Z X
through an adequate pipe. Please refer
to the purchasable accessories shown in
the installation manual (if circular pipe:
minimum diameter 120 mm). The route of
the flue must be as short as possible.
Connect the product to the power net by
Z X
using an omnipolar switch.
Regulations concerning the discharge of air
Z X
have to be fulfilled.
Do not connect the extractor appliance to
Z X
exhaust ducts carrying combustion fumes
(boilers, fireplaces, etc.).
If the extractor is used in conjunction
Z X
with non-electrical appliances (e.g. gas
burning appliances), a sufficient degree
of aeration must be guaranteed in the
room in order to prevent the backflow of
exhaust gas. When the cooker appliance
is used in conjunction with appliances
supplied with energy other than electric,
the negative pressure in the room must not
exceed 0,04 mbar to prevent fumes being
drawn back into the room by the cooker
appliance.
– 4 –