Cub Cadet 19A70056100 Mode D'emploi page 8

Install Hanger Assembly - Triple
Bagger Model
For model number 19A70056100, follow the
steps below.
1. Install and secure the hanger assembly
onto the upright support bracket using two
carriage bolts (710-0276), two cup washers
(736-0242) and two flange lock nuts (712-
04063 ) from hardware pack 689-01419.
Figure 4-7.
Figure 4-7
NOTE: The carriage bolts (710-0276), from
hardware pack 689-01419, go in the top hole
with the nut facing the engine. The hex bolt
(710-0376), from the same hardware pack, goes
in the bottom hole.
Install Top Bagger Components-
Triple Bagger Model
For triple bagger model number
19A70056100, follow the steps below to install
the bagger components.
With the mounting brackets assembled and
in place on the tractor, follow these steps to
assemble the remaining bagger components.
1. Snap the plastic upper chute support and
chute deflector in place by first clipping
the side portion onto the bagger support
rail (1) as shown in Figure 4-8.
Figure 4-8
8 S 4 — A
ection SSembly
2. Snap the front side of the chute support
to the rail (2), as shown in Figure 4-8.
3. Attach the upper chute support to the
chute deflector using the three (3)
screws supplied in hardware pack 689-
02299. See Figure 4-9.
4. If not already installed by the factory,
install the bagger screen into the
bagger cover by first inserting one end
into the corresponding cutout mounting
hole. Make sure to feed the screen under
the lip, as in Figure 4-10.
& i
nStAllAtion
Figure 4-9
Figure 4-10
5. Install the bagger cover onto the bag
support assembly, as seen in Figure 4-11.
The plastic cover goes inside the two
mounting tabs.
Figure 4-11
6. Slide the hinge pin into the hole located
on the mounting tab, as shown in Figure
4-12. Use the cut-out windows (see inset
in Figure 4-12) to line up the hinge pin on
the other side and push pin all the way in
until it reaches the end-stop. At this point
the pin clips into place and is secured by
a tab in the bagger cover.
Figure 4-12