SOUNDMASTER NR916 Manuel D'utilisation page 14

This unit operates from a main supply of 230V ~ 50Hz.
Connect the AC power cord to the AC household main
outlet. Ensure that the voltage is as indicated on the
rating plate on the rear of the unit.
This system is designed to operate on normal 230V 50Hz
AC only. Attempting to operate this system from any
other power source may cause damage to the system
and such damage is not covered by your warranty.
Press ON/OFF (25) to turn the unit ON. Press and hold
ON/OFF (25) for 1 second to turn the unit OFF.
When no sound is produced, the unit will switch OFF automatically after 10 minutes.
Select FM mode using "FUNCTION" SELECTOR (14).
1.
Turn "TUNING" KNOB (10) to select your favourite radio station.
2.
Turn the "VOLUME" KNOB (19) to the desired volume level.
3.
Antenna Information
For FM reception there is a built-in FM antenna wire (26) at the rear of the unit. Move the wire
around to obtain the best reception.
Select PHONO mode using "FUNCTION" SELECTOR (14).
1
.
2. Remove the stylus protector and select the correct stylus type 33/45 for vinyl or 78 for
shellac records by the flip over function of the cartridge.
3 Place a record on the turntable, over the central spindle. Place the EP adapter over the
central spindle when playing 17cm EP records.
4. Set 33/45/78 RPM SPEED SELECTOR (4) to 33 / 45 / 78 rpm according to the record.
5. Move the tonearm to the beginning of the record, or to the start of a particular track.
Gently lower the tone arm onto the record to start playing.
6. To stop manually, lift the tonearm from the record and turn it back.
7. Replace the protective cap on the stylus when not in use.
POWER SUPPLY
FM RADIO OPERATIONS
LISTENING TO RECORDS
4
NR916 / English Instruction Manual