Boston Scientific LATITUDE Communicator Manuel D'instructions page 7

Complete the following steps to connect your Communicator to the MultiConnect
Converter.
1. Locate the telephone cord that came with your Communicator. Plug one end into
the telephone jack labeled
other end into the telephone jack on the back of your MultiConnect Converter.
2. Locate the antenna that came with your MultiConnect Converter. Attach it to the
converter as shown above.
3. Locate the power supply that came with your MultiConnect Converter. Plug one
end into the jack labeled
Plug the other end into an electrical outlet.
4. Your MultiConnect Converter will now attempt to connect to a cellular phone
network. When one or more of the SIGNAL lights on your MultiConnect Converter
are on, it has successfully connected. You may continue with the following steps
to connect and install your Communicator.
If the SIGNAL light(s) on your MultiConnect Converter do NOT light, contact
Note:
customer service or your healthcare provider as noted below.
5. Find the power supply that came with your Communicator. Plug one end into the
jack labeled
an electrical outlet.
on the back of your Communicator. Plug the
on the back of your MultiConnect Converter.
on the back of your Communicator. Plug the other end into
® Communicator Patient Manual Supplement | 3
LATITUDE