SSS Siedle DoorCom ISDN Mode D'emploi page 11

PC programming on site
The RS485 with our PRI 602-0 or
RS232 programming interfaces per-
mit access to the overall data
record and so to all programmable
settings of the DoorCom. For
reading and writing the configura-
tion data, the PC program identifies
itself as the Siedle program and has
full access rights to the configura-
tion.
Remote programming
Remote configuration via the public
network interface exercises the
same access rights to the configura-
tion data as the RS485/RS232 inter-
faces.
The remote configuration or remote
update is enabled using the button.
After reading out the configuration
data or after a download, the ena-
ble status is reset again. If no con-
nection is established, the enable
status is automatically cancelled
again after 10 minutes.
PC system requirements for
installation of the configuration
program
Computer at least 486, CD-ROM
drive with drawer.
Slot-IN drives are not
admissible!
Working memory: at least 64 MB
User interface: Windows 95, 98,
ME, NT or 2000, Internet Explorer
at least 4.0
Programming software with
Internet Explorer 5.5 SR2 on
CD (8 cm) and adapter cable are
provided.
Technical hotline and advice
on the DoorCom ISDN, DCI 600-...
Tel. +49 7723 / 63 420
11