Care And Maintenance; Every 50 Hours - SNDC ECOCLIM SKIMO Notice De Montage

5 blink High voltage (the tension of the battery)
Tension en dessus de
6 blink Low voltage (he tension of the battery).
Tension en dessous de
Light on A/C system gas low pressure. The pressure switch is
continuously activated for a pressure lower than 2 bars in the high
pressure part of the circuit in case of the quantity of
gas being too low (caused by a leak for example).
Light AND A/C system gas high pressure. The pressure switch is
electrical motor activated for a pressure higher than 14 bars in the high
on and off pressure part of the circuit.
Light not on but The Skimo A/C is not working properly but the default
unit not working light is not switched on. This can be due to an
electrical problem.
There are two other security systems on the Skimo A/C unit :
•
Compressor security: The compressor is equipped with a security pressure valve to protect the system in case of a pressure
switch failure.
•
Machine security: The Skimo A/C unit is equipped with a sensor that disables the Skimo A/C unit if the cover is opened.
Use only original spare parts.
•
The Skimo A/C unit must be maintained and cleaned up regularly from dust, vegetal or other wastes or combustibles
to avoid risks of fire.
The frequencies listed below are for reference only. The maintenance must be done more frequently if the working
environment can lead to clogging up, premature wear or deterioration of some parts.
•
The SKIMO A/C unit contains parts that are moving that can present a danger. Never disable the security features.
Always turn the unit and the vehicle off before opening the cover or taking the cabin panel off.
•
Switch the unit off before any maintenance.

Every 50 hours :

Clean the dust filter
Check the condenser, the ventilator, the main casing. Clean if necessary
SNDC – 274 chemin des Agriès 31860 Labarthe-sur-Lèze – France
Tél : +33 (0)5 34 480 480 - Mail :
Version
18 V 12 V
32 V 24 V
100 V 80 V
Version
10,5 V 12 V
21 V 24 V
41 V 48 V
71 V 80 V

Care and maintenance

– www.sndc.net
sndc@sndc.fr
EN
Check that the alternator supplies its nominal voltage,
and that the nominal tensions of the alternator, of the
battery and of the Skimo are identical.
Check that the battery gets charged up properly and
that the alternator is powerful enough. Check that the
vehicle's engine doesn't run at low speed for extended
periods of time (over 15 minutes)
To be done by an A/C specialist:
Check the airtightness of the A/C circuit and recharge
with R134a gas.
Check that the condenser is not clogged up.
To be done by an A/C specialist:
Check that the A/C circuit hasn't got too much gas
R134a.
Check that the default LED light works properly. Check
the fuses, the relays, the electrical harness, the
connectors and the electrical connection between the
Skimo unit and the vehicle or the machine.
Caution
Caution
p.29