Table des matières CONSIGNES DE SECURITE INTRODUCTION PROTECTIONS ELECTRIQUES CARACTERISTIQUES TECHNIQUES DESCRIPTION DE L’UNITE VERIFICATION AVANT POSE DE L’UNITE PREPARATION DES PAROIS POSE DE L’UNITE RACCORDEMENT ELECTRIQUE RACCORDEMENT FRIGORIFIQUE OUPLE DE SERRAGE DES RACCORDS FRIGORIFIQUES CHARGE DE L’UNITE UTILISATION DE L’UNITE ENTRETIEN ET MAINTENANCE OUTES LES HEURES...
Page 4
FRIGORIFIC FITTING OF THE UNIT REFRIGERANT CHARGING UNIT USE CARE AND MAINTENANCE VERY HOURS VERY TWO YEARS ANNEXES / ANNEX ES REFERENCES UTILES SEFUL REFERENCES...
Pose de l’unité • Raccordement électrique Dans le cas d’un pressostat trinary, le câblage du connecteur en sortie condenseur est le suivant : Borne 1 – Positif Borne 2 – Négatif (fil N du faisceau) Borne 3 – Fil vert/noir ou rouge blanc du pressostat trinary Borne 4 –...
Introduction Electrical protections An abnormal consumption of the ALIZE 6 unit will result in automatic safety. Overpressure or under load Technical characteristics...
Electrical connection In the case of a trinary pressure switch, the wiring of the condenser output connector is as follows: Terminal 1 – Positive supply 12 or 24V Terminal 2 – Negative or ground (Beam Wire N) Terminal 3 – Trinary Pressure Switch Green/Black or White Red Wire Terminal 4 –...
Every two years : (by a qualified technician) • Cleaning of condenser coil. • Replacement of the filter dryer (Reference in annex). • Control of pressure switch (Reference in annex).