Unit Description; Before Fitting The Skimo A/C Unit - SNDC ECOCLIM SKIMO Notice De Montage

N° Description
1 Condenser fan
2 SKIMO unit cover
3 Outside air intake grills
4 Unit cover fastening screws
5 SKIMO unit casing
6 M8 unit fasting screws
7 Fuses
8 Relays
9 Blower
10 Cab air intake
11 Wire to connect to alternator D+ signal
12 Water drain holes
13 Cabin panel adjustable bracket
14 Cabin panel
15 Air filter access grid
16 Grid fastening screws
17 Control panel
18 Adjustable air louver
19 Default signal light
20 A/C and ventilation speed selector switch
21 A/C and heater selector switch
Prior to fitting and using the SKIMO A/C unit, check the following points:
Cabin volume : Ideally the volume of the cabin is approximately 2m3 but if it is over 3m3 the performances of the SKIMO A/C unit
will decrease.
Cabin insulation : The cabin walls must be properly insulated, especially from important heat sources (engine, exhaust pipe, hydraulic
system ...). SNDC SAS cannot be held responsible in the case of poor performances of the SKIMO A/C unit caused by poor cabin
insulation.
Ceiling thickness : The ceiling thickness must be between 3mm and 60mm. If it is over 60mm, an additional plate can be fitted to
fasten the cabin panel. In this case, the four M8 screws used to fasten the SKIMO A/C unit on the roof must be replaced by M8
screws adapted regarding their length and mechanical characteristics.
SNDC – 274 chemin des Agriès 31860 Labarthe-sur-Lèze – France
Tél : +33 (0)5 34 480 480 - Mail :

Unit description

19
20
21

Before fitting the SKIMO A/C unit

– www.sndc.net
sndc@sndc.fr
EN
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
p.22