Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
•
Avoid using devices that produce heat.
Operating modes
Once the Skimo A/C unit is installed and the vehicle's engine is running, turn the control panel ventilation speed selector switch to
first speed to turn the unit on. The first ventilation speed and the air conditioning are turned on.
Adjust the ventilation speed to 1, 2 or 3 according to your requirement with the ventilation speed selector switch.
To switch the unit off, turn the ventilation speed selector switch to 0.
Switch the Skimo A/C unit off if the vehicle's or machine's engine runs on low speed for an extended amount of
time (for over 15 minutes). If not, there is a potential risk of battery discharge due to the fact that the alternator might
not supply enough power when the engine runs at low speed. The Skimo A/C unit would turn to security mode. If that
happens, refer to section 14.
It is normal for the internal thermostat to regulate the A/C unit if the blowing temperature is too low, in which case
the blowers still run but the air conditioning is turned off for a while.
SNDC SAS cannot be held responsible for condensation appearing on the cabin's surfaces. The air contains moisture
that tends to condensates on cold surfaces. Appropriate cabin insulation can prevent or lover the risks of condensation.
If the A/C circuit hasn't got the correct amount of gas, the performances of the A/C system will lower. If it seems that your
Skimo A/C unit doesn't work properly, you should take it to an A/C specialist.
Never try to repair faults by your own means. Repair and recharge of an A/C circuit must be carried out by a specialist
that is qualified, certified, equipped with necessary tools and that will use original spare parts.
If one of the security systems is activated, the air conditioning system is turned off (no more cold production) and the
default light is switched on on the control panel.
To reset the Skimo A/C unit after a security cut off, turn it off and on again. A security cut off should not be a recurring
feature. In the case of repeated cut offs, contact your qualified specialist.
Error codes :
Error code
1 blink
Overheating of the electrical motor. The temperature
of the motor went over 113°C. The unit can be reset
by switching it off and on again only once the motor's
temperature is lower than 109°C
2 blink
The battery is flat (the tension of the battery).
Tension en dessous de
3 blink
Over consumption of the electrical motor
SNDC – 274 chemin des Agriès 31860 Labarthe-sur-Lèze – France
Tél : +33 (0)5 34 480 480 - Mail :
Breakdowns and remedies
Failure
Version
9 V
12 V
14 V
24 V
36 V
48 V
60 V
80 V
– www.sndc.net
sndc@sndc.fr
EN
Caution
Check that the air way cooling the electrical motor is not
clogged up.
To be done by an A/C specialist:
Check that the A/C circuit hasn't got too much gas
R134a.
Check that the battery gets charged up properly and
that the alternator is powerful enough. Check that the
vehicle's engine doesn't run at low speed for extended
periods of time (over 15 minutes)
Check the power consumption of the Skimo A/C unit.
To be done by an A/C specialist:
Check that the A/C circuit hasn't got too much gas
R134a.
Repair required
p.28
Publicité
Table des Matières
