Arcam HDA Serie Manuel page 10

Rear Panel Connections and Controls PA240
BALANCED XLR AUDIO INPUTS
Connect the XLR outputs of your pre-
amplifier.
See "Connecting Sources and
Loudspeakers" on page EN-13.
INR INL
OUTR OUTL
+
R
4-16 OHMS. CLASS 2 WIRING
PRE-AMPLIFIER INPUTS SPEAKER TERMINALS
Connect the phono outputs of your See "Connecting Sources
pre-amplifier. and Loudspeakers" on
See "Connecting Sources and page EN-13.
Loudspeakers" on page EN-13.
PRE-AMPLIFIER OUTPUT
OUTL and OUTR provide a copy of
the signal applied to the IN L and IN
R phono sockets only, not the XLR.
Note: This is a passive output,
no additional filtering or
amplification is applied.
INPUT SWITCHES
Allow the PA240 to be configured in
different operational modes.
See "Connecting Sources and
Loudspeakers" on page EN-13.
INR INL
GAIN INPUT
25dB 31dB RCA XLR
ST BRIDGE DM
- -
+
L
RS232
This connection allows for remote control
from a third-party home automation
system or computer.
See "Network and RS232" on page EN-10.
USB
Trigger OUT allows the PA240 to control the power state of other connected
For software upgrades only.
See "USB" on page EN-10.
TRIGGER IN
USB
5V
MODE RS232 NET 100mA
TRIGGER OUT
(12V
NETWORK
This connection allows for remote control
from a third-party home automation system or
computer.
See "Network and RS232" on page EN-10.
EN-8
TRIGGER IN / OUT
Trigger IN allows the PA240 to be turned on or off by an external source.
equipment
See "Trigger IN/OUT" on page EN-10.
100mA)
POWER INLET
110-120V/220-240V~
50/60Hz 1.5kW MAX
POWER INLET
Connect the correct mains cable
here.
Please read the sections "Placing The Unit",
"Power" and "Interconnect Cables" on page
EN-6 before
amplifier!
SUPPLY
VOLTAGE
SWITCH POSITIONS
115 = 110 - 120V ~
230 = 220 - 240V ~
VOLTAGE SELECT
Ensure that the voltage
selected matches the local
power supply.
connecting your PA240