Kessel Comfort PLUS Instructions De Pose Et D'utilisation page 37

5 Initial commissioning
Connect the battery
Connect the battery connector(s) (2).
5.1 Connect to the mains voltage
Establish mains voltage (400V control units)
Connect the mains cable to the mains power supply.
Move main switch (1) into ON position.
Initialisation starts automatically.
The device checks the electrical components.
Voltage test of the standby batteries.
|3.10. Language|
Menu item
Establish mains voltage (230V control units)
Insert the safety plug into the designated socket.
Move main switch (1) into ON position.
Initialisation starts automatically.
The device checks the electrical components.
Voltage test of the standby batteries.
|3.10. Language|
Menu item
Switch on
Move main switch (1) into ON position. After a successful system test, the display shows
green LED signals readiness.
If the display does not show initialisation (
the set parameters must be checked or reset to the factory settings (
tings, the initialisation of the control unit starts automatically.
Please note that the counter for the maintenance interval is not changed by the reset to the factory settings.
5.2 Overview of configuration menu
5.3 Carrying out initialisation
During initialisation, the following input is expected:
|Language|
|Date / Time|
|Product type|
|System variant|
|Power rating|
|S1 / S3 operation|
|Maintenance interval|
Language
► Press OK.
► Use the cursor keys to select the language and confirm with OK.
|Date/Time|
Menu appears.
Date / Time
► Set the respective flashing figure in date and time and confirm with OK.
|Product type|
Menu
010-700_04
is displayed.
is displayed.
|3.10. Language|
appears.
Installation and operating instructions
1
|0 System info|
) the control unit has already been initialised. In this case,
|3.11 Reset|
). After resetting to the factory set-
2
and the
37 / 144