Publicité
Recommandations for fitting the hands
Fitting the hands
The use of a movement holder is indispensable for supporting
the lower pivot of the centre wheel. The movement holder
No. 4080.35.244 is recommended.
It can be ordered from:
ETA SA Manufacture Horlogère Suisse
Customer Service
Bahnhofstrasse 9
P.O. Box 359
2540 Grenchen
Switzerland
Phone +41 32 655 27 77
Fax +41 32 655 84 30
etacs@eta.ch
www.eta.ch
The hands must be fitted on a running movement i.e. with the
battery in place.
1.
Fit the battery with the crown in neutral position. The nu-
merical display passes automatically to the "All on"
mode.
2.
Turn the crown.
The display passes to the "Local time" mode (see In-
structions for use). All the numerals indicate zero.
The watch starts functioning.
3.
Fit the hour hand by centering it precisely at the
12 o'clock mark. Slight displacement of the hand can
be, if needed, corrected by turning the crown in the
pulled-out position.
4.
Pull the crown out and then push it back in.
The numerical display indicates flashing seconds.
Removal of hands
Only with Bergeon tool ref. 30.671-7.
CT 988333 FDE 299731 06
12.08.2008
5.
Press the crown in, while the numerals flash. The seconds are
brought back to zero.
6.
Set the minute hand precisely on the 12 o'clock mark.
7.
Synchronising the analog and the numerical display.
Proceed as follows:
- Select the neutral numerical display of the cell (see: Instructions for
use), without any indication, by turning the crown.
- Pull out crown. The R symbol appears on the upper section of the
dial.
- Turn the crown forwards or backwards till the hands indicate pre-
cisely the same time as shown by the numerical display.
- Push the crown back in.
8.
Setting the time
Proceed as follows:
- Bring back the numerical display to the "Local time" (see Instruc-
tions for use), by turning the crown.
- Pull out crown. The T symbol appears on the upper section of the
dial. The numerals indicating hours and minutes start to flash.
- Set the watch to time by turning the crown forwards or backwards
(turn the crown quickly to adjust the time by one full hour, slowly to
correct the minutes).
- Push the crown back in.
N.B.:
In case the battery is fitted in advance, then the process can be inter-
rupted without any problem even for a long time, if so desired, be-
tween the point 2 and the point 3. The hands will still be fitted at 12
o'clock and the time lapse between the two displays will be overcome
with the synchronisation operation as described in point 7.
ETA SA Manufacture Horlogère Suisse
15
Publicité
