Switching From ºc/24-Hour To ºf/12-Hour Indication; Possible Settings; Setting The Temperature; Setting The Timer Function - WANDERS Solea Elegance Mode D'emploi Et Instructions D'installation

Switching from ºC/24-hour to ºF/12-hour indication
• Press the OFF button  and the small ame button  simultaneously (2 sec) to switch from ºF (and the 12-
hour indication) to the ºC (and the 24-hour indication), and vice versa.

Possible settings

• By pressing the SET button  you can switch quickly between MAN  day temperature  lamp  ventilator
 night temperature  timer  MAN.
• MAN: this setting allows you to turn the ames manually higher or lower with the big- ame button  or the
small- ame button .
• Day temperature (): this mode allows you to set the desired daytime temperature; the remote control set
will function as a thermostat.
• Night temperature (): this mode allows you to set the desired night temperature.
• TIMER: this mode allows you to preset 2 switch-on and 2 switch-o times per 24 hours. If the night setting is
on - - -, the stove will burn on the pilot ame.

Setting the temperature

Select the day temperature or night temperature by brie y pressing SET button .
•
• Now press SET button  longer until the display starts ashing.
• Preset the temperature with buttons  or  (5 ºC is the minimum day temperature).
• Wait or press OFF button  to switch back to the thermostat-controlled system.
• In order to save the batteries you are advised to reset the night-temperature until the display shows the '- - -'
signal.

Setting the timer function

• Select the timer function by brie y pressing SET button  a few times.
Now press the SET button  longer until P1 () starts ashing.
•
• Set the hours with button  and the minutes with button .
• Brie y press SET button  for the next timing.
• Once all 4 timings have been set, press OFF button  to end the presetting.

Operation (remote control)

Igniting the re

• Open the gas turncock that is xed in the gas pipe leading to the stove.
• Press "O I" switch  on the gas control block in the "I" position.
• Turn control button  on the gas control block to the ON position.
• Simultaneously press buttons  and  on the handset. A short acoustic
signal indicates the start, and is followed by short acoustic signals (0.2
sec/signal, 1Hz.) until the pilot ame and the chief burner are ignited.
After the main burner has lit, the ame height will automatically go to
the maximum position.

Possible error messages

• Long signals (0.8 sec. signal with 0.2 sec. interval) during lighting : batteries of the receiver are almost
empty. (After hearing this signal, you can switch on the appliance for about another 10 times.)
5 seconds continuous signal : error message. One of the cables may not be connected, or the "O I" switch
•
is not in the "I" position.
• 5 short signals (0.2 sec. signal with 0.2 sec. interval) : ignition of the pilot ame and the main burner has
failed. Possible cause: air in the pilot burner pipe.
Important: If the pilot ame has gone out you must wait at least 5 MINUTES before repeating the
!
above-mentioned steps.
All manuals and user guides at all-guides.com


19