Setting The Time; Switching From ºc/24-Hour To ºf/12-Hour Indication; Possible Settings; Setting The Temperature - WANDERS Square 60 G Mode D'emploi Et Instructions D'installation

Setting the time

• Press the big-flame button  and the small-flame button  simultaneously, and the display will show
short flashes to indicate that you are in the set mode.
• When in the set mode, press the big-flame button  to set the hours, and press the small-flame button 
to set the minutes.
• Wait or press the OFF button  to return to manual control.
Switching from ºC/24-hour to ºF/12-hour indication
• Press the OFF button  and the small flame button  simultaneously (2 sec) to switch from ºF (and the
12-hour indication) to the ºC (and the 24-hour indication), and vice versa.

Possible settings

• By pressing the SET button  you can switch quickly between MAN  day temperature  lamp  ven-
tilator  night temperature  timer  MAN.
• MAN: this setting allows you to turn the flames manually higher or lower with the big-flame button  or
the small-flame button .
• Day temperature (): this mode allows you to set the desired daytime temperature; the remote control
set will function as a thermostat.
• Night temperature (): this mode allows you to set the desired night temperature.
• TIMER: this mode allows you to preset 2 switch-on and 2 switch-off times per 24 hours. If the night setting
is on - - -, the stove will burn on the pilot flame.
• Lamp: this function is not used.
• Ventilator: this mode allows you to let the ventilator go faster or slower with buttons  and .

Setting the temperature

• Select the day temperature or night temperature by briefly pressing SET button .
• Now press SET button  longer until the display starts flashing.
• Preset the temperature with buttons  or  (5 ºC is the minimum day temperature).
• Wait or press OFF button  to switch back to the thermostat-controlled system.
• In order to save the batteries you are advised to reset the night-temperature until the display shows the
'- - -' signal.

Setting the timer function

• Select the timer function by briefly pressing SET button  a few times.
• Now press the SET button  longer until P1 () starts flashing.
• Set the hours with button  and the minutes with button .
• Briefly press SET button  for the next timing.
• Once all 4 timings have been set, press OFF button  to end the presetting.

Operation (remote control)

Igniting the fire

• Open the gas turncock that is fixed in the gas pipe leading to the stove.
• Press "O I" switch  on the gas control block in the "I" position.
• Turn control button  on the gas control block to the ON position.
• Simultaneously press buttons  and  on the handset. A short acous-
tic signal indicates the start, and is followed by short acoustic signals
(0.2 sec/signal, 1Hz.) until the pilot flame and the chief burner are ig-
nited. After the main burner has lit, the flame height will automatically
go to the maximum position.

Possible error messages

• Long signals (0.8 sec. signal with 0.2 sec. interval) during lighting : batteries of the receiver are almost
empty. (After hearing this signal, you can switch on the appliance for about another 10 times.)
5 seconds continuous signal : error message. One of the cables may not be connected, or the "O I" switch
•


19