Broan NuTrone 60000 Serie Guide D'installation page 6

INSTALL ROUGH-IN PLATE & DUCT
1. Run 120 VAC electrical power cable from service panel to installa-
tion location.
2. Remove wire box cover. Remove a knockout from the wiring box.
Feed 6" of power cable through opening and attach cable to wiring
box with appropriate connector.
3. Wire black to black, white to white, and green or bare wire beneath
green ground screw. Replace wire box cover.
ALL BLOWERS - (326H ROUGH-IN PLATE SHOWN)
FLUSH WITH EDGE
FLUSH WITH EDGE OF
OF WOOD SHIMS
WOOD SPACERS
4. Mount rough-in plate to framing. Make sure top and outer edges of
rough-in plate are FLUSH with top and outer edges of spacers.
MODEL 326H BLOWER ONLY
5. Purchase a Model 457K Horizontal Ducting Kit.
Connect rectangular-to-round transitions to back side of rough-
in plate. Mount wall caps to outside wall. Tape all joints.
MODEL 325H BLOWER ONLY
5. Install a wall cap that accepts 7" round duct. Use a short section
of duct between rough-in plate and wall cap if necessary. Tape all
joints.
6. Install and finish drywall.
Go to "COMPLETE INSTALLATION" section on Page 9.
6