Safety; Intended Use; Foreseeable Misuse - FLUX F 550 Notice D'instructions Originale

1

Safety

1.1 Intended use

The high viscosity liquid pumps are used for transferring low to high viscosity, pasty, still
free-flowing media. They can be used for applications in the food industry, pharmaceutical,
cosmetical and chemical products as well as petro-chemicals.
Depending on the product to be transferred, different materials and drive motors are used.
High viscosity liquid pumps can be driven by a range of different motors.
Electrical commutator or three-phase motors and compressed air motors are available as
pump drives.
In an environment subject to explosion hazard, pumps and motors are used which have
been checked and approved according to the Explosion Protection Directive 94/9/EC
ATEX 95.
Quick action taps allow for convenient filling.
According to the design, the pumps may be used as mobile devices or they may be
permanently installed in plants. Manual as well as remote operation are possible.
During stationary use you must constantly watch the pump.

1.1.1 Foreseeable misuse

Pump and accessory material must always be suitable for the product to be transferred
(see resistance chart).
Observe the operating instructions when changing the liquid. Take possible chemical
reactions and the resulting health hazards and material damage into account.
Only operate the motors in conjunction with the pumps in the corresponding liquids.
Non-observance may result in damage to the pump and the motor and operator injury.
The high viscosity liquid pumps and the accessories are not intended to be used by
uninstructed persons or by persons with limited physical, sensory or intellectual
capabilities, unless they are supervised by a person responsible for their safety or receive
instructions from that person on how the device is to be used.
Children should be supervised to ensure that they do not play with the device.
22 / 84 Original Manual High Viscosity Liquid Pumps Type F 550
and Sanitary Pumps Type F 560