SOMFY Oximo 40 Wirefree WF RTS Notice page 29

2.3.1. Pre-programming the control point
1) Connect the motor (section: Wiring).
2) Press the Up and Down buttons on the control point: The motorised product makes
up and down movements (rapidly raising and lowering), and the control point is pre-
programmed in the motor.
2.3.2. Controlling the direction of rotation
Press the Up button on the control point:
a) If the motorised product rises (a), the direction of rotation is correct: Move onto
the section entitled "Setting the end limits".
b) If the motorised product lowers (b), the direction of rotation is incorrect: Go to the
Changing the direction of rotation stage.
2.3.2. Changing the direction of rotation
1) Press the my button on the control point until the motorised product moves up and
down: The direction of rotation has been modified.
2) Press the Up button on the control point to control the direction of rotation.
2.3.3 Adjusting the end limits
Automatic setting of the end limits (2.3.3.a)
1) Press the Up and Down buttons on the control point at the same time: The motorised
product moves up and down (moves up and down rapidly).
2) Press the my button until the motorised product moves up and down.
Setting the end limits in manual mode (2.3.3.b)
The end limits can be set in any order.
1) Raise the motorised product to the desired upper position by pressing the Up button.
2) Press the my and Down buttons at the same time until the motorised product moves.
The upper end limit is memorised.
3) Press the my button when the motorised product reaches the desired lowered position.
If necessary, adjust the position of the motorised product using the Up and Down buttons.
4) Press the my and Up buttons at the same time until the motorised product moves.
The lower end limit is memorised. The motorised product rises and stops in the
raised position.
5) To confirm the end limits, press the my button until the motorised product moves up
and down. The end limits are programmed.
Copyright © 2017 Somfy SAS. All rights reserved.
1
ON
a
b
1
1
1
3
5
Images not contractually binding
EN
2
Setting the end
limits
Changing the direction
of rotation
2
2
2
4
29