Installation; Assembly - SOMFY Oximo 40 Wirefree WF RTS Notice

EN

2. INSTALLATION

These instructions are mandatory for the home motorisation and automation professional installing the drive.
Never drop, knock, drill or submerge the drive.
Install a separate control point for each drive.
Installation recommendations
The three components that make up the Oximo 40 WireFree™ DC RTS kit must be installed on the same side as the roller shutter (3.2W SOLAR
PANEL, Oximo WireFree™ Battery, Oximo 40 WF RTS).
Minimum distance to be kept between two RTS motors: 20 cm.
-
Minimum distance to be kept between the Oximo 40 WF RTS motor and an RTS control
-
point: 30 cm.

2.1 ASSEMBLY

2.1.1 Preparing the drive
Check that the inner diameter of the tube is 37 mm or greater.
1) Fit the accessories required to integrate the drive into the roller tube:
• Either fit the drive wheel a on the drive.
• Or fit the crown b and the drive wheel c on the drive.
2) Measure the length (L1) between the inner edge of the drive head and the rim of the
drive wheel.
2.1.2 Preparing the tube
Install an Oximo 40 WT RTS motor in a roller tube with a minimum thickness of
0.5 mm and a smooth inner surface: with no welding, crimping, folding, etc. inside
the tube.
1) Cut the roller tube to the required length, depending on the motorised product.
2) Deburr the roller tube and remove
the swarf.
3) For roller tubes which are smooth
inside, cut a notch with the following
measurements:
2.1.3 Drive/tube assembly
1) Slide the drive into the roller tube.
For roller tubes which are smooth inside, position the notch previously cut on the boss
on the crown.
2) Fix the roller tube on the drive wheel using the screws or pop rivets depending
on the length (L1-5mm).
The screws or pop rivets must only be fastened on the wheel and not on the drive wheel.
26
Ø 40 x 1
Ø 40 x 1.5
Images not contractually binding
1)
2)
1)
3)
d e
6 mm 8.5 mm
7 mm 8.5 mm
1)
2)
Ø = 37 mm
a
L1 = ...
L1
2)
d
L1
Copyright © 2017 Somfy SAS. All rights reserved.
Ø > 37 mm
b c
e