SOMFY Oximo 40 Wirefree WF RTS Notice page 30

EN
Setting the end limits in semi-automatic mode (2.3.3.c)
Setting the upper automatic and lower manual end limits.
1) Lower the motorised product to the desired position by pressing the Down button.
2) Press the my and Up buttons simultaneously until the motorised product rises;
the lower end limit is set.
3) Press the "my" button to stop the motorised product.
4) To confirm the end limits, press the my button until the motorised product moves up
and down.
Setting the upper manual and lower automatic end limits.
1) Raise the motorised product to the desired upper position by pressing the Up button.
2) Press the my and Down buttons simultaneously until the motorised product lowers;
the upper end limit is set.
3) Press the "my" button to stop the motorised product.
4) To confirm the end limits, press the my button until the motorised product moves up
and down.
2.3.4. Programming the control point
The drive is in programming mode:
Quickly press the PROG button on the control point to be programmed:
The motorised product moves up and down.
The control point has been programmed in the drive
If the drive is no longer in programming mode, repeat Step 2.3.1 before performing Step 2.3.4.
2.3.5. Putting in stand-by/Waking up the motor
The Oximo 40 DC RTS motor can be put in stand-by (de-activated) during transportation or in prolonged storage.
This limits battery discharge and eliminates any risk of spurious use.
This function is only possible within 5 min of the control point being programmed.
When the motorised product is unpacked, the motor is woken-up (activated) to make the motorised product operational.
Stand-by
Press the Up, my and Down buttons on the control point simultaneously until the motorised product moves up and down.
The motor is "deactivated".
If the solar panel is connected, this must be covered to guarantee the motor is de-activated.
Activating the motor:
When the motorised product is unpacked, if necessary (installation in the dark) switch on the solar panel and press the Up and Down buttons on
the control point simultaneously until the motorised product moves up and down.
The motor is "activated" and the motorised product is operational.
30
Images not contractually binding
1 2
4
3
1 2
4
3
PROG.
Copyright © 2017 Somfy SAS. All rights reserved.