Safety Instructions - Tecno-gaz Tecno Seal Mode D'emploi

1.4

Safety instructions

1.
Our products left the plant in perfect safety condition.

2. To maintain this condition, the content of these safety instructions as well as
type plates, labeling and safety instructions attached to the machine must be
observed while handling the machine (transport, storage, installation,
commissioning, operation and maintenance).
3.
This machine is suitable for processing laminated films in the heat-sealing
process. See also chapter 2.1 "Designated use".
4.
Please check the packaging and lodge a complaint for any damage with the
carrier or parcel service immediately before installing the machine.
5. Before commissioning, ensure that the machine does not show any evidence
of damage. In case of doubt, contact the manufacturer or a service partner
authorized by the manufacturer.
6. Do not operate the machine if the power cable or the power plug is
damaged. Do not use the machine if it does not operate correctly or it is
damaged in any way. If the mains cable or the machine have been
damaged, the machine must be repaired by the manufacturer or by one of
the manufacturer's authorized service partners.
7.
The machine must be connected using the mains cable included in shipment
to a protective contact socket with a stable voltage. Operation on IT
networks is not permitted.
8.
Please place the machine on a stable base.
9. The machine must not be installed and operated in
explosive areas.
10. If the sealing machine is brought directly from a cold environment into a hot
environment, bedewing may occur. Wait until temperature equalization has
taken place.
Starting up the machine when it is bedewed causes danger to life!
11. Fuse changes and repairs must only be performed by the manufacturer or
by one of the manufacturer's authorized service partners.
12. Switch off the machine when it is not in use or remove the power plug from
the socket.
Page GB 5 9.693.004 V 4.06