Sealing Seam Test - "Seal Check - Tecno-gaz Tecno Seal Mode D'emploi

Sealing seam test – "Seal Check"
3.3
Testing of the critical process parameters temperature and contact pressure with
"SEAL CHECK".

Seal Check seal indicators are not suitable for packaging with side folds
This test should be performed before and after the daily working process and/or before/after
each load and can be documented routinely (DIN EN ISO 11607-2).
Before the test, the machine must be ready for use and the set temperature must have been
reached.
Page GB 12 9.693.004 V 4.06