Customer Service - Tecno-gaz Tecno Seal Mode D'emploi

Malfunction
Uneven material feed
or
loud running noise
Sealing seam does not hold /
is distorted
Paper side of the packaging
discolored or side gusset
shrunk
4.2

Customer service


See the attached document
0Z00H0002
Page GB 14
Possible cause
Conveyor belt guide
Conveyor belt
- damaged
- no feed
Motor
Temperature too low
sealing roller
Sealing unit
- Distance between
sealing units too large
Temperature too high
9.693.004
Troubleshooting
Replace PTFE belt on guide
unit (see page 19)
Replace conveyor belt
Check belt tension
Replace motor*
Increase temperature (see page 10)
Replace the sealing roller*
Set sealing unit clearance
to 0.5 mm*
Reduce temperature (see page 10)
V 4.06