TLV J3S-X Manuel D'utilisation page 11

Disassembly/Reassembly (to reassemble, follow procedures in reverse)
Part & No.
Cover Bolt 17
Cover 2
Connector 16
Cover Gasket 9
Drain Plug* 20
Drain Plug Gasket* 19
Spring Clip 14
X-element 13
Air Vent Valve Seat 15
X-element Guide 12
Screen 8 & J3S-X/
Float Cover 11 J5S-X
Screen 8
J6S-X
Screen Holder 21
Float 3
Orifice Plug 4
Orifice Plug Gasket 5
Orifice 6
Orifice Gasket 7
* Option
Figure A
Spring Clip
Groove
X-element Guide
Disassembly
Use a wrench to remove
Lift up the cover
Remove the connector
Remove gasket only if worn or
damaged
Use a wrench to remove
Remove and clean sealing surfaces
Squeeze the spring clip to remove it
from the guide
Remove from the X-element guide
Use a wrench to remove
Remove without bending
Lift straight up and out while rocking
slowly
Lift straight up and out while turning
Remove without bending
Remove, being careful not to scratch
its polished surface
Use a wrench to remove
Remove gasket only if worn or
damaged
Use a wrench to remove
Remove the gasket and clean sealing
surfaces
Figure B
̶ 10 ̶
Reassembly
Coat threads with anti-seize and
tighten to the proper torque
Align the cover with the connector to
attach the cover
Insert the connector
Replace with a new gasket only if
worn or damaged
Coat threads with anti-seize, and
tighten to the proper torque
Replace with a new gasket, coat
surfaces with anti-seize
Squeeze the spring clip and insert it
into the X-element guide (figure A)
Make sure the X-element is not
upside down (figure B)
Coat threads with anti-seize and
tighten to the proper torque
Fix with Air Vent Valve Seat and make sure
the X-element can be inserted smoothly
Align arrows and insert, insert tab on
bottom into guide on body and push
in until top is flush (figure C)
Place on the screen holder, making
sure the top of the screen does not
stick up out of the body
Place on the ledge inside the body,
making sure the rounded side is on top
Insert into body, being careful not to
scratch its polished surface
Coat threads with anti-seize and
tighten to the proper torque
Replace with a new gasket only if
worn or damaged
Coat threads with anti-seize, and
tighten to the proper torque
Replace with a new gasket, coat
surfaces with anti-seize
Figure C
X-element
Tab
Air Vent
Valve Seat
Arrow on
Float Cover