Printing With The Auto Card Feeder - Sony UP-D6500 Mode D'emploi

Printing with the Auto Card Feeder

This procedure describes how to print with the
optional Auto Card Feeder installed.
1
Turn on the printer.
The READY lamp blinks for a few seconds, then
lights steadily when ready to print.
Power switch
Note
When using the SCSI connection, do not turn the
printer on or off while the host computer is
accessing other SCSI devices, such as a hard disk.
2
Confirm the printer's READY lamp is lit, then turn
on the computer. When using the SCSI connection,
turn on all other SCSI devices before turning on
the computer.
3
Hold the top of the Auto Card Feeder cover, and
pull it to open.
Note
The platform inside the Auto Card Feeder lowers.
Be careful not to pinch your finger beneath it.
Ready lamp
4
Put the cards on the platform inside the Auto Card
Feeder. Insert cards with magnetic stripe so that
the stripe faces down and toward the rear.
We recommend using soft cotton gloves to handle
cards, to avoid fingerprints and dirt.
Stack the cards neatly. Before placing,
massage the card stack to avoid sticking.
5
Close the Auto Card Feeder cover.
6
Send the image data from the computer. The
READY lamp blinks while the data is being sent to
the printer. Sent image data is temporarily stored in
the image memory of the printer.
7
Send the Print command from the computer to start
printing.
The PRINT lamp on the printer lights, and cards
are fed to the printer automatically as printing
begins.
Refer to the software documentation for details of
program operations on the computer.
After printing, the printer returns to the standby
condition.
23
Printing