Scsi Cable Connection (Up-D6500) - Sony UP-D6500 Mode D'emploi

Connection

SCSI Cable Connection (UP-D6500)

Notes
• Turn off the power to all devices when making connections.
• Connect the power cords last.
• Up to seven peripheral devices can be connected to the SCSI bus.
• Refer to the operating manual for each device for details about peripheral device connections.
• Insert the SCSI cable connectors firmly, as far as they will go.
• The total length of the SCSI cable connected to one host computer should be no more than three meters.
• When only the printer is connected to one host computer, the SCSI cable length should be no more than one
meter.
• Do not use the parallel interface when using the SCSI interface.
Personal Computer
To SCSI
connector
1) Refer to the computer operating manual for the type of SCSI cable to use. When connecting other SCSI devices, refer
also to the manuals supplied with those devices. Use a cable compatible with the SCSI2 standard.
2) The SCSI bus allows connection of other SCSI devices by daisy chain between the computer and printer, and after the
printer. Refer to the operating manuals of those devices for the settings on those devices.
3) For SCSI connections, the SCSI ID should be set by the SCSI ID switch (page 19). Also, if one of the SCSI connectors
on the printer is not used, set the leftmost (terminator) switch on the SCSI ID switches to ON (page 19).
18
Preparation
UP-D6500
To SCSI connector
SCSI cable 1)
SCSI ID
To AC IN
To power outlet
Connects to other devices, if needed.
2)