JAC VARIA SELF 1000 Notice D'utilisation Originale page 10

Ensure first of all (after verifying electric compatibility) that the motor is rotating in the right
direction. If the blade stops in the cutting channel and the machine goes into error mode,
disconnect immediately and switch two phase wires in the plug.
For machine operation, please refer to the "Operation" chapter.
5.5 Danger:
If the user or the machine is in danger, you must use the main isolator switch to cut the power supply
to the machine.
Remove the plug from the power socket before any maintenance and/or servicing work;
Do not touch the blade, even if it is stationary.
To replace the blade, have the work done by your approved dealer.
Always wear cut-resistant gloves (EN 388:2003 version B= 5) when replacing the blade or when
working in the vicinity of the blade.
Any maintenance work or replacement of parts must be carried out by a qualified individual.
6 CONTROLS AND SAFETY FEATURES
6.1 Controls:
Your slicer is equipped as standard with a mechanical keyboard (fig.1, n°4).
6.2 Work area:
The work area is at the front of the machine (fig.3, n°20).
6.3 Safety features:
This machine is equipped with:
An encoded magnetic safety switch (fig.6, n°21,22).
A safety cut-out magnet.
A magnetic sensor
Which stops the machine when the front door (fig.1, n°10) is opened using the lock (fig.1, n°9).
An encoded magnetic safety switch (fig.6, n°24).
A safety cut-out magnet.
A magnetic sensor
Which prevents the machine from starting when the cover is opened (fig.1, n°1).
A mechanical safety lock (fig.6, n°23)
Which prevents the cover (fig.1, n°1) from being opened while the machine is in operation.
English
10