Honda FJ500 Manuel De L'utilisateur page 54

4. Set the collar to the spring, and position them between the right side of the
clutch lever and the handle bracket (see page 50).
With the spring and collar set in this position, slide in the lever fulcrum pin.
5. Align the projection on the lever fulcrum pin to the groove on the side of the
handle bracket hole and then set the snap pin in the direction shown in the
illustration (see page 50).
6. Check the lock lever and clutch lever for smooth operation.
If the lock lever and clutch lever do not operate smoothly, or the clutch
engages by squeezing the clutch lever without pushing the lock lever, take
the tiller to your servicing dealer.
51