STOTT PILATES SPX Reformer Manuel Du Propriétaire page 6

Assembly Instructions
1 Insert gearbar [26] into middle gearbar slot [5]
with the concave indentations facing wooden
standing platform [4] [see inset].
3 nOTE: With two people, tilt Reformer onto one side.
As one person steadies Reformer, insert free ends
of ropes [22] through back of pulleys [25], then
through chrome tubes [27] underneath carriage.
5 Return Reformer to upright position.
6
2 Insert pulleybars [23] into receptacles [34] at rear
of Reformer and tighten star knobs at base of
receptacles. Ensure eyehooks on top of pulleybars
are parallel to aluminum rails [15] and that star
knobs are fully tightened so there is no movement of
the pulleybars.
4 Tie a knot leaving a 6-8" tail to prevent ropes
from passing back through chrome tubes.
6 Position shoulder rests directly over screw holes.