Publicité
Les langues disponibles
Les langues disponibles
Step 2. Removing Springs
1 With 7/16" wrench, hold fixed cube nut in place.
3 Remove spring from spring anchoring bar.
5 Repeat steps 1 to 4 on remaining springs.
Spring anchoring Bar
Fixed cube Nut
RequiRed TOOLS:
2 Using second 7/16" wrench on opposite side
of spring anchoring bar, loosen nylon locknut.
This may require a bit of torque.
nOTE: diScaRd used nylon locknuts. (New nylon
locknuts are provided with new springs.)
4 Pull spring out of the plastic spring holder.
6 Remove spring sleeves from old springs
and slide onto new springs, if applicable.
-
two open
end wrenches
1/2" (13
)
7/16" (11
)
mm
x
mm
13
Publicité
