Publicité
Les langues disponibles
Les langues disponibles
RequiRed TOOLS:
-
flat
head screwdriver
-
two open
end wrenches
1/2" (13
mm
3 Insert spring bolt through the corresponding hole on
spring anchoring bar.
5 Hold fixed cube nut in place with 7/16" wrench.
Using second wrench, tighten the new nylon locknut.
nOTE: dO NOT ReuSe old nylon locknuts.
7 Repeat steps 1 to 6 for remaining springs.
)
7/16" (11
)
x
mm
4 Thread nylon locknut into spring bolt.
6 Both nylon locknut and fixed cube nut should be
snug against the spring anchoring bar.
8 Write date of installation on the sticker provided
with spring replacement package. Affix sticker
on the underside of Reformer carriage.
Springs should be replaced every 24 months,
or as needed within that period.
15
Publicité
