Traction; Brakes; Polishing Pad Motor - COMAC CM 50 hs Mode D'emploi

A "flashing zero" appears on the display when the battery charge level is getting too low.
The pad motor automatically turns off. Batteries must be recharged as soon as possible.
A residual charge remains so as to move the machine to the recharging point.

TRACTION

TRACTION TRACTION TRACTION
This machine has an electronically controlled traction with three forward and three
reverse speeds. To move the machine first turn the key and then move man-present lever
(1) on the handlebar forward (to move forward) or backward (to move in reverse). Push it
forward and the machine will move. Rotate selector to adjust forward movement speed.
An audio signal will sound when the machine is moving in reverse.

BRAKES

BRAKES
BRAKES BRAKES
The machine has an electronic braking system. To brake, in normal conditions, just
release the man-present lever. If the service brake does not operate properly or in case of
need (parking, danger, etc.) actuate the mechanical brake by pushing the lever down (1)
(red signal lamp ON).

POLISHING PAD MOTOR

POLISHING PAD MOTOR POLISHING PAD MOTOR POLISHING PAD MOTOR
WARNING! WARNING! The pad motor starts only when the machine is moving forward WARNING! WARNING!
in order to prevent damage to the floors.
The pad motor is electronically controlled. The red signal lamp on the dashboard starts to
flash when preset overload limits are reached. After a few seconds the motor will stop
and the pad switch signal lamp will turn off. To start the motor up again you must turn
the main switch key off and on. If the motor stops again you must find the cause of the
overload to prevent damage to the motor.
OPERATION OPERATION
OPERATION OPERATION
29
1
1
2