Putting The Batteries In The Machine; Type Of Battery; Battery Maintenance - COMAC CM 50 hs Mode D'emploi

4. 4. 4. 4.

PUTTING THE BATTERIES IN THE MACHINE

PUTTING THE BATTERIES IN THE MACHINE
PUTTING THE BATTERIES IN THE MACHINE PUTTING THE BATTERIES IN THE MACHINE
The batteries must be housed in the battery compartment below the seat panel and
must also comply with the requirements given in CEI 21-5 standards.
Battery compartment dimensions are: 540x640 H480 mm.
When inserting the batteries:
1. Use handle (1) to lift the hood and insert the safety strut
2. Position the batteries in the battery compartment
5. 5. 5. 5.

TYPE OF BATTERY

TYPE OF BATTERY TYPE OF BATTERY TYPE OF BATTERY
The machine must be powered using:
• flat or tubular plate lead-acid traction batteries with free electrolyte;
gel-technology gas recombination hermetically sealed traction batteries.
•
NO OTHER TYPES CAN BE USED.
Each battery is composed of DIN cells connected in series and supplying 6V voltage
across the terminals.
Maximum weight and dimensions are:
width 178 mm, length 295 mm, height 424 mm; weight 51kg
These must be handled using transport and hoisting equipment suitable for their size
and weight.
Lift using the handles on the top.
They must be housed in the battery compartment with connection terminals directed
towards the rear of the machine.
They must be connected in series together in order to have a 24V voltage across
terminals.
Electrical connections must be made by trained and specialized personnel from the
COMAC Service Center.
6. 6. 6. 6.

BATTERY MAINTENANCE

BATTERY MAINTENANCE BATTERY MAINTENANCE BATTERY MAINTENANCE
Comply with the battery manufacturer's instructions for battery maintenance and
recharging.
Pay special attention when selecting the battery charger: it differs according to battery
type and capacity.
PREPARING THE MACHINE PREPARING THE MACHINE PREPARING THE MACHINE PREPARING THE MACHINE
24
1