Pentair INTELLIPOOL Manuel page 34

The components of a set are factory matched by a single radio code which prevents any risk of interference with other IntelliPool
several ponds nearby ...).
1 - Remove the blue rubber cover of the Probe unit.
2 - Click on "radio programming" with a paper clip. > The yellow LED lights up, Probe unit then emits a radio code learning for 5 min note: starting
up the remote display will activate automatic recognition/programming of a radio code.
3 - Remove the battery hatch.
4 - Remove the insulating film batteries.
5 - The remote display goes into learning mode radio > The remote display displays values . > Replace the battery hatch.
1
4
Add a new Indoor remote display
This RADIO mode enables to add a second remote display to set up a second source of information reading from your pool.
1 - Press RESET briefly (0.5 s) on the original remote display «A» (it displays «radio»). Note: Pressing more than 4 s until the beep activates a
alarm values reset.
2 - Remove the battery hatch of the new remote display «B».
3 - Remove the battery insulation film of the new remote display.
4 - The new remote display switches to radio programming mode.
5 - The new remote display displays the same values as the original remote display. Replace the battery hatch. Note: If the values of alarms
original remote display have been customized, it must be refered manually to the new remote display for identical alarms.
1
A
4
32
Reprogramming the original indoor remote display
A
B
B
2
5
2
A
5
3
A
3
B
B
(neighborhood,
®