Pentair INTELLIPOOL Manuel page 30

Indoor display
REAR VIEW
1
2
3
BATTERY HATCH
The display is intended for indoor use. Do not expose to sunlight or rain. Exposure to
sunlight (UV) or rain can damage it irreversibly.
28
model :
433.445 MHz
serial :
MADE IN FRANCE
4
TRIPOD
Use only alkaline batteries of high quality
resistant to temperatures of +70 ° C (ex
DURACELL PROCELL)
5
Alarm sound switch
ON / OFF
calib on alarm
Temperatures
Remote display provided alternately (in ° C or ° F, see p34) the air temperature along with the cloud symbol and
temperature of water accompanied by the words "water" symbol.
Note : direct exposure of the Radio relay to sunlight disturbs the air temperature measuring. If the installation
includes two Radio relays, is that which the jumper is ON, which will provide these values , see p13. In the event
of a discrepancy between displayed temperature value and the reference value provided by a standard instru-
ment, it is possible to recover this gap via "calibration", see p34.
Snow / freezing risk detection
The freezing pictogram for the air temperature is displayed if the temperature measured by the Radio relay is
below +3°C (37.4° F).
REFRESH VALUES
A return (ON > CALIB > ON or ON > ALARM > ON)
"refresh" the values on the screen after 20 seconds
ON mode:
- device operating
CALIBRATION mode:
- personalise alarm values
- calibrate pH and RedOx/ORP sensors
- calibrate water temperature
- choose units
ALARM mode:
- personalise alarm values