Publicité
Les langues disponibles
Les langues disponibles
|
Owner's Manual
If you experience a problem with your G4, please follow the troubleshooting steps below to restore
performance. If further assistance is required, contact Zodiac Customer Service. Please have your serial
number and date of purchase available when you call.
Problem
Cleaner does not move or moves slowly.
Cleaner patterns, does not cover entire pool. • Use Flow Gauge to verify proper flow. Increase flow to
Cleaner gets stuck at steps.
Cleaner stays on walls or edge of pool.
Cleaner wonʼt climb walls.
®
®
Zodiac
Baracuda
G4 Automatic Aboveground Pool Cleaner
Solution
• Confirm that the main drain is closed.
• Use Flow Gauge to verify proper flow. Note: In water
16° C (60° F) or less, it may be necessary to increase
flow to compensate for the reduced flexibility of the
hose and diaphragm.
• Check diaphragm for damage or wear.
• Backwash filter and empty pump basket.
• Check for air in system. If water level in pump basket
drops or you see excessive air bubbles in the pump
basket or coming from the return lines, there is air in the
system. Check hose connections, tighten all fittings at
pump and check gasket in pump basket for wear.
improve climbing. Reduce to move cleaner off the walls.
• Ensure return fittings are directed down. Add a
return diverter if necessary.
• Make sure hose is not coiled or kinked. Lay in sun
to straighten if necessary.
• Verify correct positioning of hose 1,5 m (5 ft.) from
cleaner.
• Confirm proper hose length.
• Use Flow Gauge to verify proper flow.
• Confirm proper hose length. Shorten if necessary.
• Use return jets to guide cleaner.
• Using Flow Gauge as guide, reduce flow to cleaner.
• Verify correct positioning of hose weight 1,5 m (5 ft.)
from cleaner.
Note: Cleaner may not climb walls in some vinyl pools
or pools with safety ledges.
• Using Flow Gauge as guide, increase flow to cleaner.
• Verify correct positioning of hose weight 1,5 m (5 ft.)
from cleaner.
ENGLISH
Troubleshooting
Page 9
Publicité
