Télécharger Imprimer la page

Zodiac BARACUDA G4 Guide Du Propriétaire page 5

Piscine hors-sol nettoyeur automatique
Masquer les pouces Voir aussi pour BARACUDA G4:

Publicité

Les langues disponibles

Les langues disponibles

|
Owner's Manual
Connect the Hose
RISK OF SUCTION ENTRAPMENT HAZARD, WHICH, IF NOT AVOIDED CAN RESULT IN SERIOUS
INJURY OR DEATH. READ THIS MANUAL IN ITS ENTIRETY BEFORE INSTALLING AND OPERAT-
ING THE CLEANER. Ensure that your vacuum suction fi ttings installed in your pool for connection of
your suction-side pool cleaner are certifi ed as being compliant with applicable safety standards such as
IAPMO SPS 4. Do not block the suction fi ttings in the pool, the suction opening on the cleaner, or the
cleaner hoses with any part or your body. Do not expose your hair, loose clothing, jewelry, etc. to any
suction outlet fi ttings in the pool/spa or on the cleaner.
Submerge the hose completely, removing all air. Tip: Turn on the pump, place the hose in front of the
return line until it is flooded. Turn off the pump.
To connect to a dedicated suction line:
1. Insert the male end of the hose into the large end of the 45° elbow.
2. Connect the elbow to the safety vac wall fitting.
3. Angle the elbow upward towards the water surface.
To connect to a skimmer:
The FlowKeeper
TM
valve must always be used in single skim-
mer installations. The valve regulates flow to ensure the pool pump
and cleaner run properly. It is pre-set at the factory to optimize the
performance of the cleaner, but offers three (3) settings to adjust the
flow. The lower the setting number, the lower the flow. To adjust, pull
the handle and move setting up or down. The red tab can be used to
open the valve and stop the cleaner.
If the pool has more than one skimmer, connect the hose to
the one closest to the pump.
The parts used to connect the hose, and the sequence in which they
are installed depends on the type of skimmer.
Deep Skimmer
45 Elbow
4 ½ in. Connector
FlowKeeper
Valve
Valve Cuff
1. Remove the skimmer basket.
2. Insert the valve fitting and connect the FlowKeeper with the arrow pointing down towards
the skimmer pipe.
3. Attach the hose protector net to the hose section that goes into the skimmer.
4. Choose the fitting combination that best suits the skimmer to complete the connection.
®
®
Zodiac
Baracuda
G4 Automatic Aboveground Pool Cleaner
WARNING
Hose
Protector
Net
Shallow Skimmer
45 Elbow
FlowKeeper
Valve
Valve Cuff
ENGLISH
Page 5
Hose
Elbow
Dedicated
Cleaner Line
FlowKeeper
Adjustment
Hose
Protector
Net
4 ½ in.
Connector

Publicité

loading