Eurosystems MFL 03 Manuel D'utilisation page 26

be changed every 60 hours or so of work.
Lift the machine as described in the "HAN-
DLING AND TRANSPORT" chapter.
Then proceed as follows:
4 . 17 4 . 17 4 .18 4 .18 4 .19 4 .19
INFORMATION!
Use a syringe (not included) for easier
and safer extraction.
INFORMATION!
Use SAE 80 or equivalent oil.
Proceed in reverse order to reassemble
the wheel.
Checking the tightness of
fasteners and guards
Cleaning
Inflation
Greasing
Blade adjustment
Blade replacement
Blade sharpening
Cable adjustment
Base oil change
Motor
No fuel; top up.
Check the position of the accelerator.
Check that the spark plug cap is properly inserted.
The motor does not
start
Check the conditions of the spark plug and clean or replace if necessary.
Check that the fuel cock is open (only for motor models for which the cock is
provided).
Motor power
Air filter dirty, clean it.
decreases
Correct the blade clearance
Irregular grass
Re-sharpen blade.
cutting
Replace blade.
Check the transmission cables.
The cutting bar is not
working.
Belt broken.
Wheels are not
Check the transmission cables.
turning
Contact the nearest authorised service centre if the problem cannot be solved.
10.7 TYRE INFLATION
We recommend checking tyre inflation
before each machine use. The recom-
mended value is 21 PSI (1.5 bar).
4 .2 0 4 .2 0
CAUTION!
Before inflating the tyre, always check
the maximum PSI value on the tyre.
11. CLEANING AND WASHING
DANGER!
Before proceeding, read and understand
the chapter "SAFETY INSTRUCTIONS"
in its entirety.
12. MAINTENANCE PLAN
Always before starting the machine - check that there are no untightened
screws, bolts and/or nuts and that the bonnets and protection systems are
intact and correctly fitted.
After each use
As needed
After each use and after each wash
When cutting is not effective due to too much clearance between the two
blades
When blade sharpening is no longer possible or when a dent cannot be
fixed by sharpening
Loss of blade cutting edge or dent
If operation is not as according to the manual
60 hours
See specific manual
13. TROUBLESHOOTING
Possible cause
Wait for all the hot parts to cool down (at
least 20 minutes) before washing and/or
cleaning the machine or the interchange-
able equipment. Use compressed air or a
sponge with neutral detergent and water.
Do not use pressurised water to wash the
machine and/or interchangeable equip-
ment. Doing so can damage the motor
and any electrical systems or batteries.
Avoid excessive use of water near labels.
In the event of damage, labels must be
replaced before using the machine and/
or the interchangeable equipment again.
How often
CAUTION!
CAUTION!
See chapt.
-
11.
10.7
10.1
10.2
10.3
10.4
10.5
10.6
See chapt.
7.1.
7.2.
Specific motor
manual
Specific motor
manual
Specific motor
manual
Specific motor
manual
10.2.
10.4.
10.3.
10.5.
Contact a special-
ised workshop.
10.5.