Models With Sanitising System; General Features; Starting The Sanitation Cycle - Jacuzzi Opalia Serie Utilisation Et Entretien

Models with
sanitising system

General features

In models with sanitation system,
fill the tank with the liquid provided
for sanitising the water circuit.
air-water mixture adjustment
knobs (where included) (A)
hydromassage cycle on/off button (B)
hydromassage cycle LED (C)
sanitation cycle on/off button (D)
sanitation cycle control/alarm LED (E)
disinfectant tank cap (or flap) (F)
For maximum safety, the electronic
circuit which controls the various
functions prevents from start the
sanitation cycle when a hydromas-
sage is in progress and vice versa.

Starting the sanitation cycle

J
acuzzi® tubs may be equipped with a sanitation system pre-fitted at the factory.
F
C
B
The very last step of installation consists in filling the specific tank fixed to the metal frame of
the tub with disinfectant. The tank has a capacity of over 1 litre and is connected with a tube
to the inlet on the edge of the tub concealed by the flap or cap (F).
We recommend the use of J-MX 07 disinfectant, suggested by Jacuzzi®, which can be found
at Jacuzzi® Service Centres and Authorised Retail.
To start the sanitation cycle, hold the button (D) pressed for approximately 4 seconds
(this will prevent starting the cycle accidentally).
Operate the adjustment knobs on the face plate (A) to shut off the air: this will prevent
forming foam while the pump is running.
Also check that all the hydromassage nozzles are open.
38
F
A
A
E
D
by JACUZZI ®
F
D
E
B
C
E
B
C
D