Models With Two Pumps - Jacuzzi Opalia Serie Utilisation Et Entretien

Models with two pumps

and water temperature
maintenance system
General features
hydromassage cycle on/
off button (pump 1) (B)
hydromassage cycle on/off but-
ton (pump 2); this is automatically
operated with the water temper-
ature maintenance system (B1)
hydromassage cycle on/off but-
ton (pump 2); present in mod-
els without water temperature
maintenance system (B2)
To move from one colour to the next, or to change the sequence, repeatedly press the
key.
Where the water level in the tub is below that required for hydromassage, the light will
function at reduced power.
It is also possible to turn on the light when the tub is empty, using it as a courtesy light
(the light will function at reduced power in this context too).
T
his is a low-power electric water heater, which lights up at the same time as the pump
and which compensates for the cooling of the water due to evaporation). The heater is
provided with a safety thermostat which turns it off automatically when the water reaches a
threshold of 40°C.
Press the button (B) and/or (B1/B2): to light up the corresponding LED.
In applicable models, press the button (B1) to start the water temperature mainte-
nance system.
Press button (B) and/or (B1/B2) to stop the hydromassage before the time (the corre-
sponding LED will also go out).
In applicable models, press the button (B1) again to stop the water temperature maintenance
system.
A special electronic device prevents starting the pump(s) if the water level is too low
and emits a long beep; in this case, add the necessary amount of water and press the
button (B) and/or (B1/B2) again.
41
B
B1
B
B2