Change Engine Oil; Change Oil Filter (If Equipped); Service Air Filter - Briggs & Stratton SNAPPER 7800946-02 Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Maintenance

Change Engine Oil

WARNING
!
DO NOT attempt any maintenance, adjustments or
service with engine and blade running. STOP engine
and blade. Disconnect spark plug wire and secure
away from spark plug. Engine and components are
HOT. Avoid serious burns, allow sufficient time for all
components to cool.
1. Drain the fuel tank completely.
2. Remove the dipstick (A, Figure 14), then turn the
mower on its side. Allow the oil to drain from the oil
fill tube into an appropriate container. Dispose of
used oil properly.
3. Place the mower upright, then fill the engine with
engine oil to the 'full' mark on the dipstick. Refer
to the section entitled 'Oil Recommendations'. Do
not overfill.
A
Figure 14: Draining the engine oil
IMPORTANT: Drain the fuel tank before tipping the
machine. DO NOT tip the machine with the carburetor
or spark plug down. Oil from the crankcase will satu-
rate the air filter and cause the engine to be hard to
start or not start at all. If contamination does occur, the
air filter will have to be replaced.

Change Oil Filter (if equipped)

1. Drain the oil from the engine. Refer to the section
entitled 'Change Engine Oil'.
2. Remove the oil filter (B, Figure 14) and dispose of
properly.
3. Before you install the new oil filter, lightly lubricate
the oil filter gasket with fresh, clean oil.
4. Install the oil filter by hand until the gasket contacts
the oil filter adapter, then tighten the oil filter 1/2 to
3/4 turns.
18
5. Add oil. Refer to the section entitled 'Change
Engine Oil.'.
6. Start and run the engine. As the engine warms up,
!
check for oil leaks.
7. Stop the engine and check the oil level. It should
be at the top of the full indicator on the dipstick.

Service Air Filter

!
Never start or run the engine with the air cleaner
assembly (if equipped) or the air filter (if equipped)
removed.
NOTE: Do not use pressurized air or solvents to clean
the filter. Pressurized air can damage the filter and
solvents will dissolve the filter.
1. Remove the fastener (A, Figure 15) and the air
filter cover (B).
2. Remove the pre-cleaner (C) and the filter (D).
3. To loosen debris, gently tap the filter on a hard sur-
face. If the filter is excessively dirty, replace with a
new filter.
4. Wash the pre-cleaner in liquid detergent and
water. Then allow it to thoroughly air dry. Do not oil
the pre-cleaner.
B
5. Assemble the dry pre-cleaner to the filter.
6. Install the filter and pre-cleaner into the base (E).
Make sure filter fits securely in the base.
7. Install air filter cover and secure with fastener.
Make sure the fastener is tight.
A
Figure 15: Air filter and pre-cleaner
WARNING
B
D
E
www.snapper.com
!
C

Publicité

Table des Matières
loading

Table des Matières