Stopping The Vehicle - Reely 2103650 Notice D'emploi

Move the throttle/brake lever on the remote control very carefully and drive slowly until you are familiar with
how the vehicle responds to the remote control. Do not make sudden adjustments to the remote control
levers.
Never point the remote control antenna directly to the vehicle, as this greatly reduces the range. The great-
est range is obtained when the remote control and vehicle antennas are upright and parallel to each other.
If the vehicle shows a tendency to move to one side, adjust the steering trim on the remote control accord-
ingly.
Discontinue use immediately if the vehicle does not respond as expected, or if the vehicle stops responding
to the remote control. If this occurs, the drive/remote control batteries may be nearly empty, or the vehicle
may be too far from the remote control.
A coiled/damaged receiver aerial, disturbances on the radio channel used (e.g. other models, radio trans-
missions from other devices, Bluetooth
be a cause of unusual vehicle responses.
Before you replace the empty drive battery with a fully charged battery and continue the trip, it is essential
to wait at least 5 - 10 minutes until the engine and the speed controller have cooled down sufficiently.
i) Stopping the vehicle
To stop the vehicle, proceed as follows:
• Release the throttle/brake lever on the remote control so that it is in the neutral position, and then let the vehicle
coast to a standstill.
• At standstill, the motorcycle tilts on one side on the crash bar. Now switch off the speed controller by pressing and
holding the on / off button for more than 0.5 seconds. The red LED in the on / off button goes out.
Do not touch the drive (gears, drive chain), do not hold the rear wheel firmly. Never move the throttle / brake
lever on the transmitter!
Caution!
The motor, speed controller and drive battery become very hot during use! Do not touch these parts im-
mediately after use – burn hazard!
• Disconnect the vehicle battery from the speed controller. Unscrew the plug-in connection completely.
• Then switch off the remote control.
, WLAN) or adverse transmission/reception conditions could also
®
39