Stopping The Vehicle - Reely Rocker 4WD RtR Notice D'emploi

Stop driving immediately if the vehicle does not respond correctly to remote control commands. If this
occurs, the vehicle/remote control batteries may be nearly empty, or the vehicle may be too far from the
remote control.
A damaged receiver antenna, interference on the wireless channel (e.g. from other devices, Bluetooth
Wi-Fi) or poor reception/transmission conditions may cause the vehicle to respond incorrectly.
The receiver is powered by the speed controller/vehicle battery, therefore the vehicle may not move cor-
rectly when the vehicle battery is nearly empty (e.g. the steering servo may not work properly).
For example, the vehicle battery voltage may drop momentarily at full throttle, and the receiver may not
receive the required voltage as a result. If this occurs, the vehicle will accelerate, but the steering servo will
not respond correctly. Discontinue use immediately and use a new, fully charged vehicle battery.
If the vehicle battery is empty, wait for at least 5 - 10 minutes until the motor and speed controller have
cooled down. You can then use the vehicle again with a fully charged battery.
k) Stopping the vehicle
To stop the vehicle, proceed as follows:
• Release the throttle/brake lever on the remote control so that it is in the neutral position, and then let the vehicle
coast to a standstill.
• Wait until the vehicle has stopped, and then switch off the speed controller (move the switch to the "OFF" position).
Do not reach into the wheels or drive components or move the throttle/brake lever on the remote control.
Do not hold the vehicle by the wheels!
Warning!
The motor, speed controller and drive battery become very hot during use! Do not touch these parts im-
mediately after use – burn hazard!
• Disconnect the vehicle battery from the speed controller. Unscrew the plug-in connection completely.
• Then switch off the remote control.
38
or
®