Adjusting The Shock Absorber; Cleaning And Maintenance; General Information; Before And After Each Use - Reely 2103650 Notice D'emploi

1:4 motocyclette électrique rtr
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

10. Adjusting the shock absorber

At the upper end of the shock absorber, the spring tension can be adjusted by turning the knurled wheel.
The shock absorbers could be mounted at different positions at the top and bottom. However, the manufacturer has
already chosen an optimal position here, and in addition, a change has only a small effect on the driving behaviour.
As with a "real" motorcycle, the shock absorber (or the rubber seals in the shock absorber) is a wearing part. If the oil
runs out of the shock absorber (for example, the rear rocker gets heavily oiled, dripping marks), the seals or shock
absorbers must be replaced.

11. Cleaning and maintenance

a) General information
Before cleaning or maintenance, the speed controller must be turned off and the drive battery must be completely dis-
connected from the speed controller. If you have previously used the motorcycle, allow all parts (such as the engine,
speed controller etc.) to cool down first.
After you have finished using the vehicle, remove all dust and dirt (e.g. using a clean long-haired brush and a vacuum
cleaner). Compressed air aerosols can also help to remove dirt.
Do not use cleaning sprays or conventional household cleaning chemicals. These may damage the electronic compo-
nents and discolour the plastic parts or chassis.
Never wash the vehicle with water, e.g. with a high-pressure cleaner.
To wipe the body or the driver figure, a soft, slightly moistened cloth can be used. Do not rub too hard, as this may
result in scratch marks.
b) Before and after each use
Engine vibrations and impacts during driving may cause certain parts and screw fittings to become loose.
Before and after each use, check the following:
• Firm seat of all screw connections
• Check that the speed controller, on/off switch and receiver are secure
• Condition of the tires
• Check that all cables are attached (they should not touch moving parts of the vehicle)
Check the vehicle for any signs of damage before and after each use. If there are any signs of damage,
discontinue use immediately.
Only use genuine spare parts when replacing worn vehicle parts (e.g. tyres) or defective vehicle parts.
44

Publicité

Table des Matières
loading

Table des Matières