Technical Data Ro Bc14/36 Charger, Ro Bp18/2 And Ro Bp18/4 Battery; Function Of The Unit; Changing The Battery (A); Emergency Stop Button (B-1) - Rothenberger ROMAX 4000 Instructions D'utilisation

2.1

Technical Data RO BC14/36 Charger, RO BP18/2 and RO BP18/4 battery

Battery, art.-no.: 2,0Ah 1000001652 /
4,0 Ah 1000001653
Typ/ model ...................................... RO BP18/2
Voltage ........................................... 18 V DC
Capacity ......................................... 2,0 Ah / 4,0 Ah
Charging voltage............................. 20,75 V DC
Charge current ................................ 4A / 8A
Charging temperature ..................... 0° - 46° C
Max. discharging temperature. ........ -15°C +75°C
Approx. charging time (90% full) ..... ca. 40 / 80 min.
Weight ............................................ ca. 400 / 670g
Recharge battery pack before first use!
3

Function of the Unit

3.1 Changing the battery
Insert battery until the catch clicks into place. (LED flashes briefly = Contact made). To remove
press the catch and take out the battery.
If the required voltage is not delivered by the battery, the LED will flash and a tone se-
quence will be issued during renewed starting. Charge the battery in the charger.
3.2 EMERGENCY STOP Button
If there is any danger to personnel or the machine during the pressing process, press the
EMERGENCY STOP button immediately and release the ON switch. The valve will open and
the piston will return to its initial position.
3.3 To switch on
Press the ON button until the pressing process has been completed. The motor cut out indicates
the end of the moulding cycle.
3.4 To turn the press jaw
The press jaw can be turned through 270° depending on the application.
3.5 LED
The white LED's lights up by starting the press cycle (up to 30 sec. after end of the press cycle).
The white LEDs flash: after 40,000 pressing processes the LEDs flash after every pressing
process as an indication of the need for the next inspection. An internal counter keeps a record
of the number of pressing since leaving the factory.
3.6 To insert the press jaw
Remove battery!
 Open the bolt (1).
 Insert the appropriate press jaw for the job in hand (2).
 Lock the bolt (3).
18
Charger, art. no.: EU 1000001654 /
AUS 1000001655 / USA CND 1000001656/
UK 1000001691
Typ/ model ........................................
RO BP18/4
Li-Ion Battery
Input voltage .....................................
Input frequency .................................
Input power .......................................
Charging voltage ...............................
Max. charge current ..........................
Rated output .....................................
No. of battery cells ............................
Weight ..............................................
ENGLISH
RO BC14/36
Charger for 18V Li-
Ion Akku
220V – 240V AC /
100 – 120´V AC
50 – 60 Hz
85 W
12-42V DC
3A
68 W
4-10
ca. 600 g
Pay attention to the electrical outlet
voltage! Check the label on the
bottom of the charger!
(A)
(B-1)
(B-2)
(B-3)
(C)
(D)