Installing The Handle Bar; Install/Empty Grass Catchment Basket; Mulch Kit; Lateral Grass Ejection - Grizzly Tools BRM 56-163 BSA Q-360 Traduction De La Notice D'utilisation Originale

GB

Installing the Handle Bar

Caution! When installing
the handle bar, ensure that
the Bowden cables are not
squashed.
1. Fasten the lower handle bar (4)
using the bar fastening screws
and wing nuts.
You can determine the desired
tilt by selecting one of the pos-
sible screw positions.
3. Unfold upper handlebar (1) and
push locking lever (20) toward
D
bar.
4. Fix the Bowden cables to the
bar using the cable clamp (5)
Install/empty grass catchment
basket
Caution: Do not operate the
equipment with the grass col-
lection box or impact protection
installed incompletely. Risk of
injury!
Assemble grass catchment bas-
ket (19):
1. Pull plastic loops (28) over basket rods
(27).
Fixing the Grass Collection
Box onto the Equipment:
2. Lift up shock protection (6).
3. Hook the grass collection box (19) into
the mounting provided for this (29) on
the rear of the equipment.
4. Release the impact protection (6). It
holds the grass collection box in posi-
tion.
100
Dismantling/Empty out the
Grass Collection Box:
5. Lift the impact protection (6) and re-
move the grass collection box (19)
6. Empty catchment basket (see chapter
„Disposal / Environmental Protection")
and re-install it.

Mulch kit

Prior to using the mulch kit, the
lateral ejection canal has to be re-
moved (see
Attaching mulch kit
1. Remove the collection box
( 19), if used.
2. Lift the impact protection (6).
3. Push in the mulch kit (23). The
bracket (23a) snaps into place.
Remove mulch kit
4. Lift the impact protection (6).
5. Push in the bracket (23a) and
remove the mulch kit (23).

Lateral grass ejection

Before using the lateral grass
ejection, the mulch kit (
has to be inserted and the grass
collection box (
removed.
Install lateral ejection canal
1. Unlock the lateral impact protec-
tion (15) by pulling the locking el-
ement (15a) to the left and open-
ing the lateral impact protection
(15).
2. Mount the lateral ejection chan-
nel (24) and remove the lateral
impact protection (15). It holds
the side ejection channel (24) in
position.
).
23)
19) has to be