Replacing The Air Filter; Change / Adjust Spark Plug; Changing The Engine Oil - Grizzly Tools BRM 56-163 BSA Q-360 Traduction De La Notice D'utilisation Originale

ing a piece of wood or plastic. Clean
the vent holes, ejection hole and blade
area especially. Do not use hard or
pointed objects, which could damage
the equipment.
• Oil the wheels from time to time.
• Before each use, check the lawnmow-
er for obvious defects such as loose,
worn or damaged parts. Check that all
nuts bolts and screws are sitting firmly.
• Check covers and guards for damage
and that they are sitting correctly. Re-
place if necessary.

Replacing the Air Filter

Do not operate the equipment
without the air filter otherwise dust
and dirt will get into the engine and
result in damage to the machine
1. Release the screw at the air fil-
ter cover (14) and flip open the
cover
2. Remove air filter (13).
3. Replace a defective air filter
with a new filter (see "Spare
Parts").
4. To install, place new air filter
(13) into the air filter cover (14)
5. Close the air filter cover and
fasten screw again.

Change / adjust spark plug

A worn spark plug or a spark gap
that is too large will result in a re-
duction of engine performance.
1. Disconnect the spark plug con-
nector ((
plug by simultaneously pulling
and turning.
11) from the spark
2. Unscrew spark plug (34) coun-
ter clockwise with a spark plug
socket.
3. Check the spark gap using a
feeler gauge (available from
specialist shops). The spark gap
must be at least 0.75 mm.
4. If necessary, adjust the gap by
carefully bending the ground
electrode on the spark plug.
5. Clean the spark plug with a wire
brush.
6. Insert the cleaned and adjusted
spark plug or replace a dam-
aged spark plug with a new one
(Champion XC92YC) (recom-
mended torque 20 Nm, deter-
mined with a torque wrench).

Changing the Engine Oil

Change the engine oil with the
petrol tank empty and the engine
warm.
• Change the engine oil for the
first time after around 5 operat-
ing hours then every 50 operat-
ing hours or annually.
• Dispose of the used oil in an
ecofriendly manner (see "dis-
posal / environmental protec-
tion").
1. Remove the spark plug connector
( 11).
2. Open the oil tank cover (
pump out the motor oil with an oil
pump.
3. Refill with engine oil (see "Initial Op-
eration").
GB
7) and
105