Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Adjust front wheels
The lawn mower is extremely flexible and
manoeuvrable thanks to the special con-
struction of the front wheels.
These are to be adjusted according to the
specific situation as follows:
1. The alignment of the wheel is
fixed once the clamping brack-
ets (28) snaps into place. If
the wheel is desired in another
running direction, lift clamp-
ing bracket to release it. Bring
wheel into new position and
clamping brackets snaps into
place once again.
2. Should the front wheels remain
able to move freely, lift the
clamping brackets (28) and do
not place them in the opening,
but rather set them on the plate
beside it.
Operation
Observe noise control and local
regulations.
Starting and Stopping the
Engine
Warning! Petrol is flammable.
Start the engine at least 3 m
away from the filling location.
Start the equipment on a sturdy,
level base, if possible not in long
grass. Ensure that the cutting tool
is touching neither objects nor the
ground.
Regularly check petrol and oil level
(see „Initial Operation") and refill in
due time.
Start the engine:
1. Insert the charged battery
(
25) (as described in the
section on „Removing/inserting
the battery"
2. Pull the safety catch (3) towards
the handle bar and hold it.
3. Press the start button (22) in the
tool tray (21). The motor starts.
Stopping the engine:
4. Release the safety loop (3). The
motor switches off and the knife
is braked.
5. Remove the battery (
from the device
Regularly examine the knife
stopping device:
Release the safety loop (3). The
motor switches off and the knife is
braked. The knife must stop within
7 seconds.
Mowing
1.
Start the engine
2.
Wheel drive:
On: Pull the drive catch (2)
towards the handle bar. The
mower moves forwards.
Off: Release the drive catch (2)
The equipment stops.
Working Instructions
•
As far as possible, mow the lawn
when it is dry in order to protect the
turf.
GB
).
25)
103
Publicité
Chapitres
Table des Matières
