Residual Risks; Assembly; Assembling The Curved Handle - Grizzly Tools ERM 1743-20 Traduction De La Notice D'utilisation Originale

GB
more than 75 m long and suitable
for outdoor use. The power cable
wire cross section must be at
least 2.5 mm
unroll cable drums before use.
Check the cable for damage.
• To fix on the power cable, use
the cable suspension intended
for the purpose.
• Keep the power cable away
from the cutting tool when
working. The cutting blades
may damage the power cable
and result in contact with live
parts. Always run the power
cable behind the operator. The
extension cable can be acci-
dentally severed. Risk of elec-
tric shock!
• Do not use the power cable to
pull the plug from the socket.
Protect the power cable from
heat, oil and sharp edges.
• Switch off the equipment and
disconnect the plug from the
socket if the power cable is
damaged. If the power cable is
damaged, it must be replaced
by the manufacturer, the cus-
tomer services of the same, or
a qualified person, in order to
avoid hazards.
• Do not connect a damaged
power cable to the mains. Do
not touch a damaged power
cable when it is connected to
the mains. A damaged power
cable may result in contact with
live parts.

Residual risks

Even if properly operating and handling
this electric tool, some residual risks will
28
. Always completely
2
remain. Due to its construction and build,
this electric tool may present the following
hazards:
a) Injuries caused by moving parts;
b) Ear damage if working without ear pro-
tection;
c) Lung damage, if suitable respiratory
protection is not worn;
d) Damage to your health caused by
swinging your hands and arms when
operating the appliance for longer pe-
riods of time or if the unit is not held or
maintained properly.
Warning! During operation, this
electric tool generates an electro-
magnetic field which, under certain
circumstances, may impair the
functionality of active or passive
medical implants. To reduce the
risk of serious or lethal injuries,
we recommend that persons with
medical implants consult their doc-
tor and the manufacturer of their
medical implant before operating
the machine.

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.

Assembling the Curved Handle

For a simple holmm installation,
select cutting height 20 mm (see
„Adjusting the cutting height").
1. Remove the two pre-installed
butterfly nuts (2a) from the
lawnmower housing (7). Insert
the lower bar (3) into the slot on
the lawnmower housing (7).