Attaching The Foot Control - JUKI MO-2800 Manuel D'instructions

Preparing the machine / Using the machine
CAUTION:
Be sure to turn OFF the power switch before
plugging/unplugging the controller.

Attaching the foot control

Plug foot control into the machine socket (A) and then into
main socket (B). The foot control regulates the sewing
speed. The sewing speed can be adjusted by increasing or
B
A
decreasing the pressure on the foot control.
"WARNING''
This appliance has a polarized plug (one blade wider than
the other).
To reduce the risk of electric shock, this plug is intended to fit
in a polarized main socket only one way.
If the plug does not fit fully in the polarized main socket,
reverse the plug. If it still does not fit, contact a qualified
electrician to install the proper polarized main socket. Do not
modify the plug in any way. (for USA, Canada only)
Main Power/light switch
The main power/light switch is conveniently placed on the
handwheel side of the machine in front of the socket.
I = On with light
O = Off
* After pressing the switch, the power will be turned OFF
in two or three seconds.
CAUTION:
Perform these following steps when you are not using
your sewing machine.
1. Be sure to turn OFF the power switch.
2. Be sure to remove the power plug from the wall outlet.
3. Do not place a thing on the foot controller.
Looper cover
To open, press to the right with your thumb in the indent pro-
vided and tilt the cover towards you. To close push it up and
press lightly to the right. The cover engages automatically.
Safety device: The sewing machine is equipped with a
safety device in order to prevent malfunction. In any of the
following cases, the safety device works to prevent the sew-
ing machine from running.
* When the looper cover is opened
* When the cloth plate is opened
* When the presser foot is raised
8